Electrician in Gin Gin, QLD

Electrical, solar and air conditioning in Gin Gin

Gin Gin is a country town inland from Bundaberg, and the work here is a mix of houses in town and properties on the roads around it. A good number of the houses are older, on generous blocks, and some are timber and high set with a lot of tin overhead. Out of town we are on farm and acreage blocks with a long drive. We plan each job by asking where the house is and how far the supply has to travel.

Houses in Gin Gin are often high set, so the work happens up a flight of stairs or underneath, over a gravel or concrete floor. The space under a high set house suits cable runs and the outdoor air conditioning unit, but we check the ground height and any stored items first. The meter box is usually on a side post or the front wall, and the switchboard can be inside a laundry or on a verandah. We ask you to clear the stairs and the underfloor access before we arrive.

Older Gin Gin houses are often timber with wide verandahs, tin roofs and wiring that has been added to over many years. Heat sits under the iron, so air conditioning matters, but old boards and thin ceilings make that harder. Solar suits large clear roof faces, though the verandah roof and trees decide where panels can go. Storms inland bring strong gusts and lightning, so we look closely at earthing and protection on boards and inverters.

What we do here most

What Gin Gin houses keep needing

Gin Gin houses tend to be old, tall and built of timber and tin, so the work is about getting gear in and wires safe.

Air Conditioning Installation

Cooling a high set house with several rooms

A high set house in Gin Gin has a lounge and two bedrooms that all bake under tin. We look at whether one outdoor unit can feed several indoor units, and how the pipes run down the stairs side or under the floor. Then we fit the indoor units, run the pipes and cable, connect them and test each room.

Solar Panel Installation

Panels on a roof with a wide verandah

Older houses in Gin Gin often have a main roof with a lower verandah roof running around it. We look at the pitch and the sheets, check the rafters, and work out which face gets the most sun without being shaded by the verandah or a tree. Panels are fixed to the rafters through the iron, and we seal each fixing against water.

Electrical Maintenance

Checking old timber house wiring

A timber house that has been in the family for many years is about to change hands or get a new tenant. We open the switchboard, test the safety switch, and look at the lights, power points and the cable in the roof space for brittle insulation or old repairs. We tell you what we find and what should be replaced before it fails.

Solar Inverter Installation

Replacing an inverter after a nearby lightning strike

A storm has passed over a Gin Gin property and the inverter now shows a fault light or nothing at all. We check the isolators and the panel strings, test the output and the connection to the switchboard, and look at the earthing. If the unit is beyond repair we fit a new one in a shaded spot and test it.

If it is urgent

If the air conditioner or power fails in the heat

  1. 1Check the switchboard for a tripped breaker or safety switch, and switch it back on once only.
  2. 2Leave the roof, the space under the house and any wiring in the ceiling alone.
  3. 3When you ring 0741 536 493, tell us whether the house is high set, in town or out on a road, and what the board looks like.
Call 0741 536 493

Common questions

Frequently Asked Questions

What work do you do?

We do electrical, solar and air conditioning work. That covers Solar Panel Installation, Solar System Design, Solar Inverter Installation, Solar Battery Storage, Solar Battery Installation, Air Conditioning Installation, Split System Air Conditioning, Electrical Wiring and Electrical Maintenance. Each one has its own page on this site.

Which places do you work in?

We work in Bundaberg, Bundaberg Central, Walkervale, Svensson Heights, Woodgate, Kepnock, Moore Park, Bargara, Childers, Norville, Gin Gin and Avondale. If your property is somewhere else nearby, ring and ask, because the list is where we name our work rather than a hard boundary.

Do you work on both homes and businesses?

Yes. The work is much the same in principle, but a shop or an office usually has a bigger switchboard and more circuits to look at. Tell us which kind of property it is when you ring and we will plan the visit around that.

Can you come and look at the property before I decide?

Yes. We can visit to see the switchboard, the meter box, the roof or the wall where the new equipment would go, and talk through the options with you. Visits are booked by phone or through the form on the contact page.

Can you design a solar system around how my household uses power?

Yes, that is what Solar System Design is for. We look at the roof, the direction it faces, any shade, the switchboard and the meter, and talk with you about when the household uses most of its power. The layout is worked out from those things rather than from a standard package.

Can I add a battery to the solar system I already have?

In most cases, yes. We start by looking at the existing inverter and how the system is wired, because that decides which type of battery can be fitted and where it connects. Once that is clear, we talk through the options and where the battery would sit.

Will a battery keep my house running in a blackout?

It depends on how the battery and inverter are wired, because not every setup runs the house when the grid is off. Some are set up to feed only a few circuits, such as the fridge and lights, while others cover more. We explain which circuits would stay on before anything is fitted.

Does a solar system need approval before it is switched on?

Grid connected solar in Queensland needs an application to the local network, which around Bundaberg is Ergon Energy Network. It is dealt with as part of the job, and the system is switched on only once that is sorted out. We explain where yours is up to when we hand it over.

What is the difference between a split system and a ducted system?

A split system is one indoor unit on a wall, joined by pipework and cable to an outdoor unit, and it cools the room it sits in. A ducted system has one outdoor unit and ducts running through the roof space to vents in several rooms. We can talk through which suits your house after seeing the layout and the roof space.

Where do the indoor and outdoor units of an air conditioner go?

The indoor unit goes high on a wall with room to blow across the space. The outdoor unit sits on a bracket or a slab outside, as close as is sensible, and needs clear space around it so air can move. We check both positions, and the run of pipework between them, before any work starts.

Will my switchboard need work to take a new air conditioner or battery?

Sometimes, and sometimes not. We open the switchboard first and look at the main switch, the spare ways and the earthing, then tell you whether the new equipment can connect as it is. If the board needs work, we say so before the job starts.

What does electrical maintenance involve?

It starts with looking at what is already there: the switchboard, the switches, powerpoints and light fittings, and any equipment you are worried about. We test what we can reach and tell you what we find. If something needs replacing, we talk it through with you first.

Local, and on the phone

Planning work in Gin Gin

Tell us whether the house is in town or out on a road, and whether the meter box is up the stairs or at ground level. That tells us how we reach the board and the roof.

0741 536 493

24 hours a day, 7 days a week

Not urgent? Send us the job instead