Electrician in Kepnock, QLD

Electrical, solar and air conditioning in Kepnock

Most of our work in Kepnock is in ordinary residential streets off Elliott Heads Road, on the southern side of Bundaberg. These are family homes on suburban blocks, usually with a carport, a back deck and a shed behind the house. Some houses have stood for decades and some are recent builds, so one street can hold a switchboard with old fuses next to one that is fully modern. We find out which we are dealing with when we open the switchboard cover, and that decides what else the job needs.

Access in Kepnock is mostly easy. Driveways are wide enough for a ute, side gates open onto the back yard, and the meter box is normally on the front or side wall of the house. Corner blocks sometimes put the meter on the wrong side from the street, so we check before we plan a cable run. On a low set house one ladder usually reaches the roof. Street parking is generally fine, though we ask you to keep the driveway clear so we can unload close to the work.

Many of Kepnock's older houses are low set, with tin roofs and little insulation above the ceiling. Heat builds up under the iron through a Bundaberg summer, so a bedroom split system can feel like it is fighting the roof all afternoon. Older switchboards may have no safety switch and few spare ways, so we look at the board before adding an air conditioner or an inverter. Newer homes in the suburb tend to have tidy boards and clear roof space, and the work there is mostly about positions and cable runs.

What we do here most

What Kepnock homes keep needing

A lot of Kepnock houses were built or fitted out years apart, so the board, the roof and the gear on the wall rarely match.

Electrical Wiring

Switchboard upgrade before a kitchen renovation

A Kepnock family is moving the kitchen and adding a dishwasher and a new oven, but the board still has old fuses and no spare ways. We open the switchboard, check the main switch and the earthing, and work out what the new circuits need. Then we run the cables through the roof space, fit the new board and test every circuit before we hand it back.

Split System Air Conditioning

Bedroom split system under a hot iron roof

The back bedroom of a low set house takes the afternoon sun through the roof and stays warm well after dark. We look for a wall where the indoor unit can sit, a spot outside for the other unit, and a short route for the pipes and cable. Then we mount, connect and test the system and show you how the controller works.

Solar Inverter Installation

Replacing an inverter cooking on a western wall

Some inverters in Kepnock hang on carport or side walls that take the full afternoon sun, and heat is hard on them. When one fails we take it off, check the panel strings and the isolators, and look for a cooler wall, ideally under the eave. We fit the new inverter, connect it, test it and hand it over.

Solar Battery Installation

Adding a battery to an older solar system

A system fitted some years ago on a Kepnock house may have no space left on the switchboard and no obvious wall for a battery. We check the existing inverter, the board and the cable route, then choose a spot out of the sun, off the ground and clear of the carport door. The battery is fitted, connected and tested, and we walk you through what it does in a blackout.

If it is urgent

If the air conditioner stops on a hot afternoon

  1. 1Check the switchboard for a tripped breaker or safety switch, and switch it back on once only.
  2. 2Leave the outdoor unit cover, the switchboard cover and anything that smells burnt alone.
  3. 3When you ring 0741 536 493, tell us your street, whether the house is low set, and whether the board has old fuses or switches.
Call 0741 536 493

Common questions

Frequently Asked Questions

What work do you do?

We do electrical, solar and air conditioning work. That covers Solar Panel Installation, Solar System Design, Solar Inverter Installation, Solar Battery Storage, Solar Battery Installation, Air Conditioning Installation, Split System Air Conditioning, Electrical Wiring and Electrical Maintenance. Each one has its own page on this site.

Which places do you work in?

We work in Bundaberg, Bundaberg Central, Walkervale, Svensson Heights, Woodgate, Kepnock, Moore Park, Bargara, Childers, Norville, Gin Gin and Avondale. If your property is somewhere else nearby, ring and ask, because the list is where we name our work rather than a hard boundary.

Do you work on both homes and businesses?

Yes. The work is much the same in principle, but a shop or an office usually has a bigger switchboard and more circuits to look at. Tell us which kind of property it is when you ring and we will plan the visit around that.

Can you come and look at the property before I decide?

Yes. We can visit to see the switchboard, the meter box, the roof or the wall where the new equipment would go, and talk through the options with you. Visits are booked by phone or through the form on the contact page.

Can you design a solar system around how my household uses power?

Yes, that is what Solar System Design is for. We look at the roof, the direction it faces, any shade, the switchboard and the meter, and talk with you about when the household uses most of its power. The layout is worked out from those things rather than from a standard package.

Can I add a battery to the solar system I already have?

In most cases, yes. We start by looking at the existing inverter and how the system is wired, because that decides which type of battery can be fitted and where it connects. Once that is clear, we talk through the options and where the battery would sit.

Will a battery keep my house running in a blackout?

It depends on how the battery and inverter are wired, because not every setup runs the house when the grid is off. Some are set up to feed only a few circuits, such as the fridge and lights, while others cover more. We explain which circuits would stay on before anything is fitted.

Does a solar system need approval before it is switched on?

Grid connected solar in Queensland needs an application to the local network, which around Bundaberg is Ergon Energy Network. It is dealt with as part of the job, and the system is switched on only once that is sorted out. We explain where yours is up to when we hand it over.

What is the difference between a split system and a ducted system?

A split system is one indoor unit on a wall, joined by pipework and cable to an outdoor unit, and it cools the room it sits in. A ducted system has one outdoor unit and ducts running through the roof space to vents in several rooms. We can talk through which suits your house after seeing the layout and the roof space.

Where do the indoor and outdoor units of an air conditioner go?

The indoor unit goes high on a wall with room to blow across the space. The outdoor unit sits on a bracket or a slab outside, as close as is sensible, and needs clear space around it so air can move. We check both positions, and the run of pipework between them, before any work starts.

Will my switchboard need work to take a new air conditioner or battery?

Sometimes, and sometimes not. We open the switchboard first and look at the main switch, the spare ways and the earthing, then tell you whether the new equipment can connect as it is. If the board needs work, we say so before the job starts.

What does electrical maintenance involve?

It starts with looking at what is already there: the switchboard, the switches, powerpoints and light fittings, and any equipment you are worried about. We test what we can reach and tell you what we find. If something needs replacing, we talk it through with you first.

Local, and on the phone

Planning work in Kepnock

Tell us whether your switchboard has old fuses or switches, and which wall the meter box sits on. That tells us where a new cable would run.

0741 536 493

24 hours a day, 7 days a week

Not urgent? Send us the job instead