Electrician in Svensson Heights, QLD
Where we work in Svensson Heights
Svensson Heights sits on rising ground, and many of its streets climb gently from one block to the next. Most of the work is in older timber houses raised on stumps, with a veranda, a flight of steps at the front and a lot of mature garden. Because the rooms are above ground, a single job often involves three places at once: the roof, the rooms, and the open space under the floor where the cables and the switchboard are often found.
Access follows the slope. A driveway may climb steeply, and gear gets carried up steps because the truck cannot get close. Under a raised house there is usually a laundry, a car space or stored boxes, and the meter box and switchboard are often on a post or a wall down there. Ladders need level footing, which on a sloped yard takes care. Tell us about steps, loose dogs and anything stored under the house that needs moving.
The older timber houses here are built to catch breezes, with high ceilings, wide verandas, louvres and corrugated iron roofs. High ceilings mean a wall unit works harder, and verandas shade the rooms but can leave one side of a roof in shade too. Timber framing makes it easy to run cable in the roof space or under the floor, though old wiring can be sitting in the same spaces. The shaded wall under the house is cooler than the roof, which may suit an inverter or battery if the clearances are right.
What we do here most
What Svensson Heights homes keep needing
The pattern is a raised timber house where the best spot for new gear is below the floor or on a shaded wall.
Split System Air Conditioning
A wall unit for a high ceiling bedroom
Tall ceilings leave cool air sitting above your head, so we look at how high the unit can go and where it will blow. The pipe often runs down a wall or past a veranda to a bracket or stand for the outdoor unit. We check that the drain falls away from the house and that the unit is clear of the stumps. The whole run is tested before we leave.
Solar Battery Installation
Fitting a battery on the wall under the house
The space under a raised house is often shaded and out of the rain, which can suit a battery. We check the wall is solid, that there is clear room around it, and that cable can run to the inverter and the switchboard without crossing a damp spot. Not every under floor space will do, and we tell you what we find when we look.
Solar System Design
Working around mature trees on a sloped block
Panels on a sloped block lose output when a tree shades the roof. We look at where the sun falls through the day, how branches shade each part of the roof, and whether trimming is something you want to do. The iron roof usually has plenty of room, so the choice is which side to use. We talk through the options before the layout is settled.
Solar Inverter Installation
Moving an inverter out of a hot spot
An inverter fixed to a western wall in full sun has a hard life through a Bundaberg summer. We look at whether it can move to a shaded wall under the house or on the side of a veranda. We check the cable length to the panels and the switchboard before deciding. Then we fit it, test it and walk you through it at handover.
If it is urgent
If the air conditioner stops on a hot afternoon
- 1Check the safety switch and the breaker for the unit in your switchboard, and push up anything that has dropped once only.
- 2Leave the outdoor unit and its cover alone, keep the steps and the space under the house clear, and do not climb onto the roof.
- 3When you ring 0741 536 493 in opening hours, tell us the street, whether the house is raised, and how many steps lead to the front door.
Common questions
Frequently Asked Questions
What work do you do?
We do electrical, solar and air conditioning work. That covers Solar Panel Installation, Solar System Design, Solar Inverter Installation, Solar Battery Storage, Solar Battery Installation, Air Conditioning Installation, Split System Air Conditioning, Electrical Wiring and Electrical Maintenance. Each one has its own page on this site.
Which places do you work in?
We work in Bundaberg, Bundaberg Central, Walkervale, Svensson Heights, Woodgate, Kepnock, Moore Park, Bargara, Childers, Norville, Gin Gin and Avondale. If your property is somewhere else nearby, ring and ask, because the list is where we name our work rather than a hard boundary.
Do you work on both homes and businesses?
Yes. The work is much the same in principle, but a shop or an office usually has a bigger switchboard and more circuits to look at. Tell us which kind of property it is when you ring and we will plan the visit around that.
Can you come and look at the property before I decide?
Yes. We can visit to see the switchboard, the meter box, the roof or the wall where the new equipment would go, and talk through the options with you. Visits are booked by phone or through the form on the contact page.
Can you design a solar system around how my household uses power?
Yes, that is what Solar System Design is for. We look at the roof, the direction it faces, any shade, the switchboard and the meter, and talk with you about when the household uses most of its power. The layout is worked out from those things rather than from a standard package.
Can I add a battery to the solar system I already have?
In most cases, yes. We start by looking at the existing inverter and how the system is wired, because that decides which type of battery can be fitted and where it connects. Once that is clear, we talk through the options and where the battery would sit.
Will a battery keep my house running in a blackout?
It depends on how the battery and inverter are wired, because not every setup runs the house when the grid is off. Some are set up to feed only a few circuits, such as the fridge and lights, while others cover more. We explain which circuits would stay on before anything is fitted.
Does a solar system need approval before it is switched on?
Grid connected solar in Queensland needs an application to the local network, which around Bundaberg is Ergon Energy Network. It is dealt with as part of the job, and the system is switched on only once that is sorted out. We explain where yours is up to when we hand it over.
What is the difference between a split system and a ducted system?
A split system is one indoor unit on a wall, joined by pipework and cable to an outdoor unit, and it cools the room it sits in. A ducted system has one outdoor unit and ducts running through the roof space to vents in several rooms. We can talk through which suits your house after seeing the layout and the roof space.
Where do the indoor and outdoor units of an air conditioner go?
The indoor unit goes high on a wall with room to blow across the space. The outdoor unit sits on a bracket or a slab outside, as close as is sensible, and needs clear space around it so air can move. We check both positions, and the run of pipework between them, before any work starts.
Will my switchboard need work to take a new air conditioner or battery?
Sometimes, and sometimes not. We open the switchboard first and look at the main switch, the spare ways and the earthing, then tell you whether the new equipment can connect as it is. If the board needs work, we say so before the job starts.
What does electrical maintenance involve?
It starts with looking at what is already there: the switchboard, the switches, powerpoints and light fittings, and any equipment you are worried about. We test what we can reach and tell you what we find. If something needs replacing, we talk it through with you first.
Everything we do here
Services in Svensson Heights, QLD
Raised timber houses, sloping blocks and mature trees decide where each of these goes on a Svensson Heights property.
Also nearby
We work in these areas too
Local, and on the phone
Tell us about your Svensson Heights house
Tell us whether the block slopes and whether there is room under the floor near the meter box. That shows us the steps and where new gear can go.
0741 536 49324 hours a day, 7 days a week
Not urgent? Send us the job instead
